SpeedFactory Racing Stainless Steel K-Series Intake Manifold Stud Kit Stud Length:55mm This stud kit looks great

This stud kit looks great and will allow you to properly clamp your manifold to the cylinder head without experiencing sealing problems

our 6-point  M8 x 1

**Do not cut the VTEC Solenoid Wire (A4)

If using an ’00 outer transmission case that had a straight reverse shaft with the SFR Billet Bellhousing then you will need our custom offset reverse shaft PN# SF-05-601-RS to properly locate the reverse idler gear and for the cases to close properly

Our studs look great and will allow you to properly clamp the intake or exhaust manifold to the cylinder head without experiencing sealing problems

SpeedFactory Racing Stainless Steel K-Series Intake Manifold Stud Kit Stud Length:55mm This stud kit looks greatIntroducing a new, cost effective yet still high performance alternative to our Titanium Stud Kits! Our high quality stainless stud kits look great and allow you to properly clamp your intake or exhaust manifold to the cylinder head without experiencing sealing problems. They are significantly stronger than your stock bolts & studs, and you will no longer have to deal with ugly and troublesome rust & corrosion. These stud kits incorporate a hex key