Watch Case & Caseback Refinishing Lathe (Lapping Machine), 16 to 45.5mm Chuck Set, Brushed and Mirror Finish watch repair tool width and height: 24CM*13CM*23CM

width and height: 24CM*13CM*23CM

sharp-nosed clamp design enables accurate manipulation of miniature watch parts

There are two kinds of tin beads

developed for dial and clockwork orientation

this tool does not contain high-concerned chemicals

Watch Case & Caseback Refinishing Lathe (Lapping Machine), 16 to 45.5mm Chuck Set, Brushed and Mirror Finish watch repair tool width and height: 24CM*13CM*23CMA precision lapping lathe for refinishing watch cases and casebacks to factory standard. The piece is held in the chuck that matches its diameter and rotated against the abrasive, so contact stays flat and even across the whole surface. This lets you restore a clean concentric brushed (satin) finish or a bright mirror polish while keeping the case's original lines and bevels sharp. That is the key difference from hand buffing, which tends to soften